|
Chassis Drive train, Brakes, Steering and anything else chassis wise |
|
Thread Tools | Display Modes |
20th February 2011, 09:53 AM | #1 |
Junior Member
Jap Spec RZ - Manual (TT) Join Date: Apr 2010
Location: royston harts
Posts: 17
|
not happy gearbox sounds nasty
after spending 3 and 1/2 hours changing my clutch and light Waite fly wheel i drove around to bed the clutch in ive done about 200 miles but now it sounds like my input shaft bearings want to get out it wasnt like this with the old clutch or is it just bad luck i just don't get it i was so careful and made sure every think was new and clean
__________________
J-spec Twin turbo 6speed manual blitz nur spec-R stainless DC active front spoiler blits boost gauge running 1bar uk spec bonnet scoop uk spec glass head lamps TEIN super street suspension |
20th February 2011, 10:14 AM | #2 |
Administrator
|
3.5 hours is pretty good time to change a clutch out, did you have a lift?
This will be why you have the rattle. All light weight flywheels come with this issue because you have now removed the dampening which the stock flywheel (dual mass) had. You either have to live with it or change back to a stock flywheel.
__________________
Martin UK6TT + Bits & Bobs 'Remember folks, the inside lane isn't just for Xmas' MSOC FAQ MSOC Members Discounts MSOC Resources |
20th February 2011, 10:22 AM | #3 |
Junior Member
Jap Spec RZ - Manual (TT) Join Date: Apr 2010
Location: royston harts
Posts: 17
|
yes mate i work in a garage and have all the tools and i work on land rovers and saabs every day. thanks for the advice im not sure i can live with this it sound so nasty
__________________
J-spec Twin turbo 6speed manual blitz nur spec-R stainless DC active front spoiler blits boost gauge running 1bar uk spec bonnet scoop uk spec glass head lamps TEIN super street suspension Last edited by mitchamillion; 20th February 2011 at 10:30 AM. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|