My Single install

[RobSheffield]

In November i started my install project, which i continued over the winter.

The bits i am/will be using are as follows
BL Manifold and DP, Tial 44m WG
Aem Ecu
Aem WB02 and guage
PHR rail
720cc injectors
Currently have a Greddy 2 row FMIC, which i will initially be reusing.
Walbro pump
BL T67 P trim

onto the build..

Car on axle stands, wheels removed for the duration of the build for security (and polishing) purposes, although it appears the car is on bricks, it is in fact on large 3 foot long blocks of wood under the centre section to provide correct working height, and allow access the the exhaust and underside for water and oil drain.



Next i removed the air filter and fmic hard pipe, to give this picture...



Unfortunately, enthusiasm and a need to keep moving and working to stave off frostbite made me forget to take any further pictures, until i got to this stage (all vacuum and boost pipework removed and heatshields off)





Which left me this small pile



few days later i removed the stock twins!